Honsberg HD1K-015GM - Flow Meter / Switch / Indicator

Sensor Analog Hall sensor
Nominal width DN 8..25
Process
connection
Female thread G ¼..G 1
(further process connections available on request)
Metering range 0.1..80 l/min
For details see
table "Ranges" Pressure loss 0.4..1.6 bar at Qmax.
Qmax. to 100 l/min
Tolerance ±3 % of full scale value
Pressure
resistance
PN 200 optionally PN 500 bar
Medium
temperature
-20..+85 °C optionally -20..+150 °C
Ambient
temperature
-20..+70 °C
Media Water, oils
(Gases and aggressive media available on
request)
Wiring see section "Wiring"
Power supply 18..30 V DC
Power
requirement
< 1 W
Analogue output 0/4..20 mA, 0/2..10 V via a 500 W
resistance after 0 V.
Switching values
S1 + S2
PNP or NPN, selectable, 300 mA max. load
in total, programmable as min. value or max.
value, resistant to short circuits,
reversed polarity protected.
Display graphical LCD display, extended temperature range -20..+70 °C, 32 x 16 pixels,
Backlite, displays value and
unit, flashing LED signal lamp with simultaneous message on the display.
Ingress protection IP 67
Electrical
connection
For round plug connector M12x1, 5-pole
Materials
medium-contact
Brass construction:
CW614N nickelled,
CW614N, 1.4310,
hard ferrite, NBR
Stainless steel construction: 1.4571,
1.4404, 1.4310, hard
ferrite PTFE-coated,
FKM
Materials, nonmedium-contact
CW614N, PPS, glass
Weight see table "Dimensions and weights"
Installation
location
Standard: horizontal inwards flow; other installation positions are possible; the installation position affects the display, metering
and switching range.